7
NEW CONSTRUCTION
WITH
Bottom REVEAL
Framed room with no drywall
At each corner of the room, measure and mark the wall down
from the ceiling 11 ¼”. Measure and mark the ceiling out from
the wall 11 ¼” plus the thickness of your bottom reveal (e.g. If
you used a single 2x4, then you would measure and mark the
ceiling out from the wall 11 ¼” + 1 ½” = 12 ¾”).
1.
Block in-between the ceiling, if necessary, to suciently
attach the cove pieces. If building code requires you to re
block, reference Step 9. In this case, combining steps 2 and 9
can save time.
2.
Using a staple gun w/ 1” (or greater) staples/brads (PROs) or
Screw Gun w/ 1” (or greater) deck screws (DIYers), attach a cove
piece butted to each side of each corner (either touching the
top of an inside corner or the bottom of an outside corner).
7.
Using your marks as a guide, snap a line (with your chalk line)
on the wall and on the ceiling around the entire perimeter of
the room.
3.
Measure, mark and then attach all other cove pieces in-between
the butted cove pieces on each corner no more than 16” O.C.
Helpful Tip: For help spacing your cove pieces evenly between
each corner visit www.archkit.com/cove-spacing to watch our
“How-To” video and see the mathematical formula.
8.
Line up the sides of your bottom ledger to the snap line on
your wall and, using a nail gun w/ 16d nails (PROs) or screw
gun w/ 3” (or greater) deck screws, fasten the bottom ledger
securely to the wall around the entire perimeter of the room.
4.
If necessary,
and/or
according to code requirements, re block
your Universal Cove Kit in between the studs along the perimeter.
9.
The 6 90° corners are reversible to t both inside and
outside corners. If you have an inside 90° corner, then
the top halves will are outward like the etchings of
an arrow. If you have an outside 90° corner, then the top
halves will come to a point like the head of an arrow.
90
o
inside corner 90
o
outside corner
Using a staple gun w/ 1” (or greater) staples/brads (PROs) or
screw gun w/ 1” (or greater) deck screws, (DIYers) install your
90° inside and/or outside corners (right angle) to align to your
snap lines and bottom ledgers.
5.
8
If applicable, install your 45° inside corners by using 4 of the
40 cove pieces that have already been modied to be used as
a cove piece as well as 45° inside corner.
6.
If you have a 45° outside corner,
a template on the side panel
of the box has been provided.
Trace your 45° outside corner
on to a piece of ½” plywood/
OSB, cut it out and then install.
(16 stránky)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Komentáře k této Příručce